Your cart is currently empty.

Search our store

More jewelry settings - post 278

20/11/2026 | Brenda Ginsberg

    

9th post in a series on jewelry settings. 

#4414

When you find a beautiful gem, you want to show it off to best advantage. You prefer to see the glint and gleam of the gemstone, not the metal mount holding it. We saw how, with only crude tools, much of the gem was originally hidden, with no chance to exploit the effects of light on the stone. But we progressed until we reached the most advanced technological methods of the 20th century, culminating in the magical invisible setting.
The consistent theme throughout has always been the same: show off more of the gem, and less of the metal that holds it.
There are a few more settings worth touching on before we close out this series.

Knife Edge
With the desire to see less metal from the front of a jewel, and with more advanced technology at hand, knife-edge settings became popular, especially during the Edwardian era. A claw-set stone was placed on a fine ribbon of metal so that the gem appeared to float. Most examples we see are done in platinum.
#4979 (sold). 

 

Spectacles
Spectacle settings are clearly named for their resemblance to granny-glasses. A stone is enclosed only around the girdle by metal, leaving the entire front and back of the stone exposed. These stones were usually cut identically on both front and back to complete the illusion.
#4411. Sautoir of sapphires in spectacle settings. 


A Word on Indian Settings
Traditional Indian jewelry has its own distinctive approach to setting stones, most famously the technique known as kundan. Rather than prongs or channels, each gem is pressed into its own individual cell of pure gold, hand-shaped to hug the stone's exact contours. The result is a design where every stone sits in its own little compartment, often surrounded by elaborate goldwork, enamel, or a cluster of smaller stones, rather than being unified into a single continuous surface the way pave or channel settings are. You'll see this frequently in pieces like archer's rings and elaborate Mughal-influenced jewelry, where the emphasis is as much on the surrounding gold artistry as on the stones themselves.  #7607  Antique Archer's Ring 22k gold enamel diamonds Indian symbolic status Archer's ring.

 

There are other, rarer settings out there — grain, tension, Belcher, en tremblant, and a few more — but we've covered the settings that matter most for a collector to know. Next time you look at a piece of jewelry, you'll see exactly what's holding those stones in place — and why it matters.

 


Questions and comments: Please email antiques@brendaginsberg.com
Find jewelry on www.brendaginsberg.com
------------------------
The full series of metal settings are in the following order:
151 introduction to metal settings
123 pulled gold 
148 collet
150 prongs
120 pave
121 channel
277 invisible 
149 gypsy /flush
278 others

Shop what you just read about: French JewelryRing Jewelry

Please note, comments must be approved before they are published

Leave a comment

Your email address will not be published. Required fields are marked *